Installation & Usage
How do I install the Charging Anti Vibration Module on my SP Connect mount?
The installation method for the SP-Connect Charging Anti Vibration Module depends on the mount you are using. For most mounts, the Charging Anti Vibration Module is installed directly in place of the mounting head. For certain mounts, the included SP
Can the cable connector be oriented independently of the Charging Anti Vibration Module’s position?
No. The cable connector of the SP-Connect Charging Anti Vibration Module cannot be positioned independently of the module's installation orientation. For technical reasons, the cable connector is permanently integrated into the design of the Charging
I want to connect the Charging Anti Vibration Module directly to my e-bike's electrical system. What do I need?
Several cable options are available for connecting the SP-Connect Charging Anti Vibration Module directly to your e-bike's electrical system. To connect the Charging Anti Vibration Module to an accessory or low-voltage output of an e-bike drive syste
Can I connect the Charging Anti Vibration Module to my e-bike display (Bosch, Yamaha, Brose, Flyer, etc.)?
In most cases, we do not recommend powering the SP-Connect Charging Anti Vibration Module through the USB port of an e-bike display. Many e-bike displays from manufacturers such as Bosch, Yamaha, Brose, or Flyer include a USB port. However, these por
Can I cut the included USB cable and connect the Charging Anti Vibration Module directly to my motorcycle battery or e-bike motor?
No. The included SP-Connect USB-C Cable is not designed to be connected directly to a motorcycle battery or an e-bike motor. The included USB-C cable is intended solely for powering the SP Connect Charging Anti Vibration Module from a suitable USB po
Which cables can I use with the Charging Anti Vibration Module?
The SP-Connect Charging Anti Vibration Module can be used with various SP Connect power cables, depending on whether you want to power it from a USB source, a motorcycle battery, or an e-bike electrical system. The following cables are available for
What do I need to connect the Charging Anti Vibration Module directly to my motorcycle battery?
To connect the SP-Connect Charging Anti Vibration Module directly to your motorcycle battery, you require the SP-Connect Cable 12V DC. The included SP-Connect Cable USB-C is designed exclusively for connection to a suitable USB power source. We recom
The included USB cable of the Charging Anti Vibration Module is too short for my motorcycle. What can I do?
If the included SP-Connect Cable USB-C (50 cm) or the optional SP-Connect Cable USB-A is too short for your motorcycle setup, there are several alternatives available. For a clean and permanent installation, we recommend using the SP-Connect Cable 12