How is the Moto Stem Mount Pro installed on the motorcycle?Updated 23 days ago
The SP Connect Moto Stem Mount Pro is installed directly into the steering stem of your motorcycle and is compatible with steering stem diameters from 12 mm to 30 mm.
Step-by-step instructions
1. Select the correct spacer cone
- Select the plastic spacer cone included in the package that matches the inner diameter of your motorcycle's steering stem.
- The included spacer cones allow installation in steering stems with diameters from 12 mm to 30 mm.
2. Prepare the spacer sleeve
- Fit the two halves of the selected spacer cone together.
- Then insert the mounting screw of the Moto Stem Mount Pro through the center hole of the assembled spacer cone.
3. Install the locking nut
- Screw the gold locking nut onto the mounting screw.
- Make sure that all three wings of the locking nut are fully seated in the corresponding recesses of the spacer cone.
4. Install the safety clip
- Slide the C-shaped safety clip into the designated groove at the lower end of the mounting screw.
5. Insert the mount
- Insert the Moto Stem Mount Pro with the assembled spacer sleeve into the steering stem of your motorcycle.
6. Adjust the mount
- Position the mounting arm as desired so that your smartphone is optimally positioned within your field of view.
7. Secure the mount
- Tighten the central mounting screw to a torque of 5 Nm.
- This expands the spacer sleeve against the inner wall of the steering stem and securely fixes the Moto Stem Mount Pro in place.
Check the installation
- Make sure the Moto Stem Mount Pro is firmly secured in the steering stem and cannot move.
- Check that all screw connections are securely tightened.
- Check that the mount is securely installed before every ride.
Summary
The SP Connect Moto Stem Mount Pro is installed directly into the steering stem of your motorcycle using the appropriate spacer cone. After assembling the spacer cone, the mounting screw is inserted through its center hole. The mount is then inserted, positioned as desired and securely clamped inside the steering stem by tightening the central mounting screw to 5 Nm.